Yedoo NUMBERS FOUR, Руководство пользователя

Страница: 6 / 21

EN
10
4.
Adjustment of brake levers
FOUR / THREE
Incline the brake levers correctly by
loosening the screw on the sleeve.
The right inclination:
Stand on the footboard, hold the
handles and stretch out your fingers
in a way that your arm and the fingers
form a single straight line. This should
be the position of the brake levers.
The upper dropout, which also makes
the footboard go lower and thus
reduces the load on the standing leg,
is intended for flat surface. Riding will
be less tiring.
5.
Installing the brake cables
FOUR / THREE
Squeeze the brake lever to the
maximum and insert the end of the
brake cable into the round lug (
1 ). Insert
the cable into the groove and tighten
the set screw (
2 ) and the nut ( 3 ). Repeat
the process with the other brake.
The rear brake cable is usually mounted
on the right brake lever and the front
brake wire on the left.
1
1
2
2
3
3
11
EN
7.
Adjustment of brakes
When braking, check that the brake
pads of both wheels fit tightly on the
rim sides. If not, you can adjust their
position via a screw that connects them
to the V-brake arms (
1 ). The pads shall
not touch the tires.
Check that the pads make enough
space (1–2 mm) after releasing the brake
levers. The distance can be adjusted by
tightening or loosening the brake cable
at the anchor screw (
2 ).
In case the brake pad is touching the
wheel when turning, symmetrically
adjust the distance of brake arms by
the tightening screws (
3 ).
6.
1 1
3 3
2
Assembly Instructions
4 Nm
TWO / ONE TWO / ONE
(Model One has only
the rear brake)
1
2
19–20 Nm
THREE / TWO / ONE
Installing the rear wheel does not
diff er from the front wheel installation.
Release the brake cable from the guide
(
1 ), insert the wheel into the fork so it is
exactly in the middle and tighten both
nuts (
2 ).
8.
Fasten the end of the brake cable in
the lock and secure with the cable tie,
then trim the tie.
9. 10.
The stand
The maximum capacity of the stand is:
FOUR / THREE 15 kg
TWO / ONE 5 kg
Do not stand on the parked scooter.
Adjusting the bowden cables
Adjust the position of the cables and
make sure they do not extend outside
the frame of the scooter and that they
do not break while bending (especially
in the rear fork area).
Installing the protective covers
TWO / ONE
Install the soft washable nylon protective
covers onto the handlebars and the stem.