Yedoo NUMBERS FOUR, Руководство пользователя

Страница: 5 / 21

9 8
EN
1.c
Assembly of the front (bigger) wheel
FOUR
Open the quick-release lever and loosen
the nut.
Make sure the front fork of the scooter is
well positioned (brake levers are facing
forward). Release the brake cable from
its holder and loosen the brake arms.
FOUR
Place the wheel into the front fork
so that is well-centred.
The tread pattern (arrow-shaped lines
on the tires) must be pointing to the
front.
Assembly Instructions
1.b 1.a
1 1 2 2
Direction
of rota-
tion
Direction
of rota-
tion
THREE / TWO / ONE
THREE / TWO / ONE
EN
2.b
Handlebar installation
FOUR / THREE
Place the handlebar tube as shown
on the picture and tighten the screws
on the stem.
FOUR
Tighten the nut until you can feel
resistance before closing the quick
release. Close it in a way that the
quick release lever points backwards
(for safety reasons).
FOUR / THREE
Insert the handlebar tube into the
front frame (
1 ) and adjust the height
according to the rider’s needs (not
higher than indicated by the line).
Check that the handlebar is upright
and properly tighten the screw
on the stem
( 2 ).
THREE / TWO / ONE
Make sure that the pad tip fits into the
correct slot and then tighten both nuts.
2.a
1.d
1
1
20–22 Nm
20–22 Nm
8–10 Nm
2
2
TWO / ONE
2.c
The highest possible height of the
handlebars is marked with vertical
grooves, at the maximum height the
grooves should be visible only partly.
Max
Assembly of the rear wheel
FOUR
is the same as the assembly of the
front wheel with the only exception of
double dropout at the rear fork. It allows
positioning the footboard according to
the road conditions. The lower dropout
enables off road riding.
3.
18–20 Nm