Yedoo ALLOY Series, Руководство пользователя

Страница: 9 / 44

9
EN
Check that the brake pads move away
from the rim sufficiently (1–2 mm) when
the brake lever is released. The distance
of the brake pads can be adjusted by
tightening or loosening the brake cable
anchor bolt (
1 ). If the brake pads come
into contact with the rim while the wheel
spins, adjust the spacing of the brake
arms symmetrically with the tensioning
bolts (
2 ).
Adjusting the rear brake is the same for
both models.
Insert the brake cable back into the
guide (
1 ). Check the brake pads during
braking, ensuring that their entire
surface fits tightly against the side of the
rim. If not, adjust the screw (
2 ), which
attaches the brake pads to the shoulders
of the V- brakes. The brake pads must
not touch the tyre.
Check that the brake pads move away
from the rim sufficiently (1–2 mm) when
the brake lever is re-leased. The distance
of the brake pads can be adjusted by
tightening or loosening the brake cable
anchor bolt (
1 ). If the brake pads come
into contact with the rim while the wheel
spins, adjust the spacing of the brake
arms symmetrically with the tensioning
bolts (
2 ).
12. 13. 11.b
1
1
1
2 2
2 2
2 2
14.
Adjusting the bowden cables
Adjust the position of the cables
and make sure they do not extend
outside the frame of the scooter
(especially in the rear fork area).
Anti-slip tapes
In case tapes become worn and
their anti-slip effect is reduced,
we recommend replacing them.
Replacements tapes are available
to buy. See more on www.yedoo.eu.
Attention: Clean and degrease
the footboard thoroughly before
application.
15. 16.
Fasten the end of the brake cable in
the lock and secure with the cable tie,
then trim the tie.