Accessing the web user interface:
Account Settings:
Click on
Account
->
Register
->
Account X
(X=1,2,3...11,12)
Parameters of the account:
Network Settings:
Account Settings:
Configuring via phone user interface
Configuring via web user interface
Register status icons on the LCD screen:
1. Press the
OK
key when the phone is idle to obtain the IP address of the phone.
You can configure the network settings in the following ways:
It shows the register status of the current account.
You can select Enabled/Disabled to enable/disable the account.
It is shown on the LCD screen to identify the account.
It is shown as Caller ID when placing a call.
It is an authenticated ID for authentication provided by ITSP (required).
It is provided by ITSP for registration (required).
It is provided by ITSP for registration (required).
It is provided by ITSP for registration (required).
DHCP:
By default, the phone attempts to contact a DHCP server in your network to obtain its valid network
settings, e.g., IP address, subnet mask, gateway address and DNS address.
Static IP:
If your phone can not contact a DHCP server for any reason, you need to configure the IP address,
subnet mask, gateway address, primary DNS address and secondary DNS address for the phone
manually.
Press the
Menu
soft key when the phone is idle, select
Settings
->
Advanced Settings
(default password: admin)
->
Network
->
WAN Port/Wi-Fi Port/VLAN
/
Web Server
/
802.1x
/
VPN
/
LLDP
/
CDP
/
NAT
to configure the
network.
Press the
Menu
soft key when the phone is idle, select
Settings
->
Advanced Settings
(default password: admin)
->
Accounts
to configure the account.
2. Open a web browser on your computer, enter the IP address into the address bar (e.g., "http://192.168.0.10"
or "192.168.0.10"), and then press the
Enter
.
Register Status:
Line Active:
Label:
Display Name:
Register Name:
User Name:
Password:
Server Host:
3. Enter the user name (default: admin) and password (default: admin) in the login page and click
Login
.
Network Settings:
Click on
Network
->
Basic
->
IPv4 Config
3
Configuring Your Phone
Note:
Check with your system administrator if any error appears during the registration process or a specific
Note:
For more information on account parameters, refer to
Configuring via web user interface
above.
configuration is required for your registration.
Note:
The IP phone also supports IPv6, but IPv6 is disabled by default.
The wrong network settings may result in the inaccessibility of your phone and may have an impact on the
network performance. Contact your system administrator for more information.
Registered
Register Failed
Registering
