Yealink MeetingSpace VC800, Руководство администратора

Страница: 120 / 295

Administrator’s Guide for Yealink VC800 Video Conferencing System
106
To configure SIP IP call via the remote control:
1.
Select
More
->
Setting
->
Advanced
(default password: 0000)->
SIP IP Call
.
2.
Check the
SIP IP Call
checkbox.
3.
Select
Save
, and then press to accept the change.
Configuring H.323 Settings
Yealink VC800 video conferencing systems support H.323 protocol. If your network uses a
gatekeeper, you can register an H.323 account for the system, and specify its H.323 name and
extension. This allows others to call the system by entering the H.323 name or extension instead
of the IP address.
H.323 settings parameters on the system are described below:
Parameter Description Configuration Method
H.323 Protocol
Enables or disables the H.323
protocol.
Default:
Enabled.
Note:
Only when it is set to Enabled,
can H.323 account be registered.
When it is set to Enabled on both
sites, the VC800 can call the far site
by dialing an IP address directly.
Remote Control
Web User Interface
H.323 Account
Enables or disables the H.323
account.
Default:
Enabled
If it is set to disabled, the system
cannot place or receive calls with the
H.323 protocol.
Remote Control
Web User Interface
H.323 Name
Specifies the name that gatekeepers
and gateways use to identify this
system. You can make point-to-point
calls using
H.323 names if both system are
registered to a gatekeeper.
Default:
blank
Remote Control
Web User Interface
H.323 Extension
Specifies the extension that
gatekeepers and gateways use to
identify this system.
Default:
blank
Note:
Users can place point-to-point
Remote Control
Web User Interface