YBA DESIGN WD202 DAC, Руководство пользователя

Страница: 6 / 16

Page 6
www.ybahifi.com
Design WD202 DAC
Discovering your WD202: Front view
1
ON/OFF Switch Press to switch on or off
2
3
SOURCE SELECTOR This cycles between all inputs of your WD202
Optical [ Coaxial [ AES/EBU [ USB [ iPod [ Optical
4
IR RECEIVER Point the remote control towards this window to control your DAC from a distance.
5
6
HEADPHONE OUTPUT Note that when headphones are connected via the Jack type 1/4” 6.3mm both
the RCA and XLR outputs are muted.
&
Using your YBA remote control
5
3
Point your remote control to the IR receiver located in the display window of your WD202
Note that
means a short press on a key while means to keep the key pressed for PRESS HOLD
more than three seconds.
1
Select the device you want to control between AMP, CD and AUX. To control the
WD202, you need to select AUX button. Note: AUX will remain the active function until
you select another device.
SOURCE SELECTOR Press this key to cycle between the inputs of your WD202
Optical Coaxial AES USB iPod [ [ [ [ [ Optical
2
MUTE Press to mute Press again to exit mute
3
AUDIO Hold to toggle between fixed and variable output. When at full range all LEDs are
lit before returning to source indication. Before switching to a fixed output make Warning
sure no source is playing and amplifier is off to avoid damaging equipment.
7
6 7
6
5
When iPod is selected buttons 5 and 7 select the previous or following track. Button 6
pauses and resumes play.
8
4
4
7
2 6 5 4 3 1 7
2
1
8
VOLUME CONTROL KEYS Use - to decrease the volume and + to increase the volume.
This is a universal control and does not require specific source selection.
SOURCE AND VOLUME INDICATOR The active source is indicated by a solid blue LED. When changing
the volume the four blue LEDs indicate the level. This changes to green when in DSD mode.
VOLUME CONTROL KEYS Use 5 to decrease the output level and 6 to increase it. Please note:
If no headphones are connected, the volume keys will change the output level of the XLR and RCA
outputs.
If headphones are connected, the volume keys will modify the output volume of the headphones only,
as the output of the XLR and RCA is automatically muted when headphones are detected.
The volume control of the XLR and RCA is completely independent of the headphones.
The volume control (full range output) can be disabled using the remote control. Details are explained in
the remote control guide (see below).
DSD Your WD202 has DSD. Any source material being used which has been recorded with DSD
encryption will be recognised by source selector changing from blue to green. This applies to
all inputs.