Operation
REMOVING THE COLLECTED WATER
There are two ways to remove collected water:
1. Use the bucket
When the bucket is full, remove the bucket and empty it.
Discard water from bucket.
-7-
Note:
Replace the empty bucket back into the unit and once seated correctly, the unit
will start up again.
- You should hear a click when the bucket is in the correct position.
- Do not remove the float in the bucket, otherwise the sensor will not be able to
sense the water level properly, so that the water will overflow from the bucket
when the bucket is full.
- If the tank is dirty, only can be used in cold or warm water wash, do not use
detergent, steel wool, chemical processing dust cloth, gasoline, benzene, thinner
or other solvent treatment, otherwise it may cause damage to the tank Water
Leakage.
