YATO YT-85803, Оригинальное руководство пользователя

Страница: 13 / 96

13
O R I G I N A L I N S T R U C T I O N S
EN
PRODUCT OVERVIEW
The electric weed brush is used to remove weeds, moss and other small plants growing on the surface with a rotating brush.
Brushes made of various types of material allow the tool to be used for ceramic, wooden and metal surfaces. Di ff erent width
brushes provide the possibility to clean both larger surfaces and gaps. Proper, reliable and safe operation of the tool depends on
appropriate use, that is why you should:
Read the entire instructions manual before the fi rst use of the tool and keep it for future reference.
The supplier shall not be held liable for any damage or injury resulting from improper use of the tool, failure to observe the safety
regulations and recommendations of this manual. Use of the tool for purposes other than those for which it was intended shall
cause the loss of the user’s rights to a warranty and statutory warranty.
PRODUCT EQUIPMENT
The product is supplied complete but requires assembly before fi rst use. The following parts are supplied with the product: wide
brush, two narrow brushes: a metal and a plastic one, and a front handle.
TECHNICAL DATA
Parameter Unit Value
Catalogue No. YT-85803
Rated voltage [V~] 230 - 240
Rated frequency [Hz] 50
Power [W] 500
Cutting speed [min
-1
] 750 – 1300
Brush diameter [mm] 100
Maximum brush width [mm] 160
IEC protection class II
Weight [kg] 3.2
Noise level
- L
pA
(pressure) [dB] (A) 83.7 ± 3.0
- L
wA
(power) [dB] (A) 94.7 ± 3.0
Vibration (main handle / additional handle) [m/s
2
] 3.390 ± 1.5
Protection rating IPX0
The declared total vibration emission value and declared noise emission value have been measured using the standard test
method and can be used to compare one tool to another. The declared total vibration emission value and declared noise emission
value can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may di ff er from the declared value depending on the manner the tool is used.
Caution! Safety measures to protect the operator, which are based on an assessment of emission exposure under actual con-
ditions of use (including all parts of the work cycle, such as the time when the tool is turned o ff or idle and the activation time),
must be speci fi ed.
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and speci fi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term “power tool” used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
Electrical safety
The plug of the electric cable must match the power socket. You must not modify the plug in any way. Do not use any