YATO YT-82187, Руководство пользователя

Страница: 18 / 112

18
EN
O R I G I N A L I N S T R U C T I O N S
Pull the battery out of the charging station by pressing the battery clamp button.
Caution! If the green LED lights up when the charger is connected to the mains, the battery is fully charged. In this case, the
charger will not start the charging process.
PRODUCT MAINTENANCE
Warning! All maintenance must be carried out with the product isolated from the mains voltage. Make sure that the battery has
been disconnected from the tool.
Inspect the saw blade, the guide rollers, and the rubber lining of the driving wheels for damage after work. If damage or excessive
tear and wear is found, replace the a ff ected parts. You can replace the saw blade as instructed above. Other components require
replacement at an authorized service agent’s.
Having fi nished working, check the tool for damage by visually inspecting the exterior and the body and the battery handle, the
functioning of the electric switch, the vents for clogging, the motor brushes for sparking, the noise level of the bearings and the
drive transmission, and how the tool starts and runs. Any irregularities found during the inspection or the operation signal the need
for repair to be done at the service centre. After fi nishing work, the housing, ventilation openings, switches, auxiliary handle and
covers should be cleaned e.g. with an air jet (with a pressure not exceeding 0.3 MPa), paintbrush or dry cloth without the use of
chemicals and cleaning agents. Clean the tools and the handles with a clean dry cloth. During the warranty period, the user is not
allowed to install any power tools or replace any components or parts, as this will void the warranty rights.