YASKAWA HV600, Руководство пользователя

Страница: 290 / 610

2.8 H: Terminal Functions
290 YASKAWA TOEPYAIHV6002A HV600 Drive Programming
• Fully stop the motor
• Cancel the Run command
• Cancel the fast stop command
Note:
•
To use the N.O. switch to input the fast stop command, set 15 (Fast Stop (N.O.)).
• Refer to C1-09: Fast Stop Time on page 224 for more information.
•
Set C1-09 [Fast Stop Time] to a correct deceleration time. If the deceleration time is too short, it can cause an overvoltage fault and failure
to stop the motor from coasting.
Figure 2.52 shows an example of how fast stop operates.
C1-09:
Figure 2.52 Fast Stop Time Chart
■
18: Timer Function
Setting Value Function Description
18 Timer Function
Sets the command to start the timer function. Use this setting with Timer Output [H2-xx = 12] .
Note:
Refer to
“
b4: Timer Function
”
for more information.
■
19: PID Disable
Setting Value Function Description
19 PID Disable
Sets the command to disable PID control when b5-01 = 1 or 3 [PID Mode Setting = Standard or Fref + PID Trim] .
ON : PID control disabled
OFF : PID control enabled
■
1B: Programming Lockout
Setting Value Function Description
1B Programming Lockout
Sets the command to prevent parameter changes when the terminal is OFF.
You can continue to view parameter setting values when the terminal is OFF [Parameters Cannot be Edited] .
ON : Program Lockout
OFF : Parameter Write Prohibit
■
1E: Reference Sample Hold
Setting Value Function Description
1E Reference Sample Hold
Sets the command to sample the frequency reference at terminals A1 or A2 and hold the frequency reference at that frequency.
V/f OLV/PM OLV/PM EZOLV
V/f OLV/PM OLV/PM EZOLV
V/f OLV/PM OLV/PM EZOLV
V/f OLV/PM OLV/PM EZOLV