YASKAWA HV600, Установка и запуск

Страница: 184 / 310

7.4 C: Tuning
184 YASKAWA TOEPYAIH6B01A HV600 AC Drive Narrow Bypass Installation & Startup
7.4 C: Tuning
◆
C1: Accel & Decel Time
No.
(Hex.)
Name Description
Default
(Range)
C1-01
(0200)
RUN
Acceleration Time 1 Sets the length of time to accelerate from zero to maximum output frequency. 30.0 s
(0.1 - 6000.0 s)
C1-02
(0201)
RUN
Deceleration Time 1 Sets the length of time to decelerate from maximum output frequency to zero. 30.0 s
(0.1 - 6000.0 s)
C1-03
(0202)
RUN
Acceleration Time 2 Sets the length of time to accelerate from zero to maximum output frequency. 30.0 s
(0.1 - 6000.0 s)
C1-04
(0203)
RUN
Deceleration Time 2 Sets the length of time to decelerate from maximum output frequency to zero. 30.0 s
(0.1 - 6000.0 s)
C1-09
(0208)
RUN
Fast Stop Time Sets the length of time that the drive will decelerate to zero for a Fast Stop.
Note:
Decelerating too quickly can cause an ov [Overvoltage] fault that shuts off the drive while the
motor to coasts to a stop. Set a Fast Stop time in
C1-09
that prevents motor coasting and makes
sure that the motor stops quickly and safely.
10.0 s
(0.1 - 6000.0 s)
◆
C2: S-Curve Characteristics
No.
(Hex.)
Name Description
Default
(Range)
C2-01
(020B)
S-Curve Time @ Start of
Accel Sets the S-curve acceleration time at start. 0.20 s
(0.00 - 10.00 s)
C2-02
(020C)
S-Curve Time @ End of
Accel Sets the S-curve acceleration time at completion. 0.20 s
(0.00 - 10.00 s)
C2-03
(020D)
S-Curve Time @ Start of
Decel Sets the S-curve deceleration time at start. 0.20 s
(0.00 - 10.00 s)
C2-04
(020E)
S-Curve Time @ End of
Decel Sets the S-curve deceleration time at completion. 0.00 s
(0.00 - 10.00 s)
◆
C3: Slip Compensation
No.
(Hex.)
Name Description
Default
(Range)
C3-01
(020F)
RUN
Slip Compensation Gain Sets the gain for the slip compensation function. Usually it is not necessary to change this setting.
Note:
Correctly set these parameters before you change the slip compensation gain:
• E2-01 [Motor Rated Current (FLA)]
• E2-02 [Motor Rated Slip]
• E2-03 [Motor No-Load Current]
0.0
(0.0 - 2.5)
C3-02
(0210)
RUN
Slip Compensation Delay
Time Sets the slip compensation delay time when speed is unstable or when the slip compensation
response is too slow. Usually it is not necessary to change this setting. 2000 ms
(0 - 10000 ms)