YASKAWA CC-Link SI-C3, Руководство по установке

Страница: 53 / 139

8 CC-Link Data List
YASKAWA TOEP C730600 83A CC-Link Installation Manual 53
Remote
Regis
ter
Name Description Request Flag
RW
W3
Write
Data
• Sets the value to be used along with RW
W2
(Command Code) as needed.
• Enable RYF (command code execution request flag)
after you set the command code and write data.
Note:
Use the extended command code 280 (Hex.) to set the DC bus voltage reference.
D1000 → PLC
Table 8.10 Remote Register (D1000 → PLC)
Remote
Regis
ter
Name Description Check Flag
RW
R0
Monitor
Data
• Monitor data is stored according to RW
W0
(Monitor
Code).
• Monitor data is updated while RYC (monitor execute
request flag) is enabled. RXC (while monitoring)
remains ON as data is updated.
RXC (while monitoring)
RW
R1
Reserved - -
RW
R2
Response
Code:
•
Sets 00 (Hex.) when there are no problems with
RW
W2
(Command Code) and RW
W3
(Write Data).
• Sets 01 (Hex.) through 03 (Hex.) if an error occurs.
• Response Code:
00 (Hex.): Normal
01 (Hex.): Write-mode error (attempted to write
during run, etc.)
02 (Hex.): Command code error
03 (Hex.): Data setting range error
RXF (Command Code Execute
Complete)
RW
R3
Read
Data
Data is set according to the command code.
Note:
Use the monitor code 0008 (Hex.) to set the DC bus voltage feedback.
◆
Terminals that Change depending on the Model of the Drive
The table below lists terminals that change depending on the model of the drive.
Table 8.11 Terminals that Change depending on the Model of the Drive
Drive Name Terminal Drive Model
1000-Series
Multi-Function Contact
Output
M1-M2 All