This product must be correctly assembled before use.
Handle
(Fig. 1A)
Slide the lower section (C) into the upper section (B).
Line up the holes on each tube, and make sure the
cable (A) is clear of the mounting holes. Secure the two
sections together with the M6x45 carriage bolt and wing
nut.
Motor housing
(Fig. 1B)
Connect socket (B) to the plug on the motor housing (7).
Secure the upper cover to the motor housing with the
supplied screws.
ASSEMBLY
7
Model SN70016-1 SKU 270-3286
Adjust knob
(Fig. 1C)
Align the rib on the spindle with the notch on the adjust
knob and push the adjust knob onto the spindle. Secure
the knob with the ST3.9x55 Philips head self tapping
screw. Place the adjust knob cover onto the top and push
to secure into place.
Wheel
(Fig. 1D)
Remove the screws and washers from the wheel bracket.
Install the wheels (13) and secure into place with the
washers and M5 x 12 screws. Push wheel covers into
place.
M6x45 Carriage
Bolt
B
C
A
ST3.9x55
Remember to connect the wire to
the plug on the motor housing!