Grounding (Fig. B)
Extension Cords (Fig. C)
WARNING
9
Electrical Safety Rules for the Battery Pack and Charger
2-pronged
polarized plug
Properly
Grounded
Outlet
Fig. C
Fig. B
More Than Not More Than
Not Recommended
25' (7.6 m)
50' (15 m)
100' (30.4 m)
150' (45.7 m)
Minimun Gauge for Extension Cords (AWG)
Total Length of Cord in Feet (met
re
s)
Recommended size of
extension cords
(when using 120 V only)
0
6
18
16
16
14
6
10
18
16
14
12
10
12
16
16
14
12
12
16
14
12
READ ALL INSTRUCTIONS CAREFULLY AND UNDERSTAND THEM THOROUGHLY. Failure to follow safety rules listed
below may result in electric shock, fire, and/or personal injury:
• Do not abuse the cord. Do not use the cord to carry the blower. Do not pull on the cord in order to remove the plug from
the outlet. Keep the cord away from heat, oil, sharp edges, or moving parts. Do not use a cord that is damaged. Replace
damaged cords immediately. Failure to do so may result in a shock or fire hazard.
• Do not place the charger where the power cord might be stepped on, tripped over, or subjected to damage.
• Use only with the specified charger to recharge a battery-powered tool with integrated batteries or a separate battery
pack. A charger that may be suitable for one type of battery may create a risk of fire when used with another battery.
• Only use a battery-powered tool with the designated battery pack. The use of any other batteries may create a fire hazard.
In the event of a malfunction or breakdown, grounding provides the path of least resistance for electric current, and reduces
the risk of electric shock. This battery charger is double insulated , and is equipped with a 2-pronged polarized plug (one
blade is wider than the other). This plug will only fit into a polarized outlet one way. If the plug does not fit into the outlet
properly, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper type of outlet. Do not alter
the plug in any way. Verify that the outlet is properly grounded. If there is a doubt, have the outlet inspected by a certified
electrician.
Do not use an extension cord for the charger unless it is absolutely necessary. When using an extension cord
,
verify that
it is in good condition, and that it is heavy enough to carry the current that the charger will draw. An undersized extension
cord will cause a drop in line voltage, which will result in a loss of power and overheating.
The table below shows the correct size of extension cord to use, according to the length of the cord and the amperage
rating that is listed on the charger's nameplate. When in doubt, use the next heavier gauge. The smaller the gauge
number, the heavier the cord.
Verify that the extension cord is properly wired and in good condition. Replace a damaged cord immediately, or have it repaired
by a qualified electrician. Keep the extension cord away from sharp objects, excessive heat, and damp or wet areas.
Use a separate electric circuit for power tools. Do not use voltage or a power source other than common household 120
V electrical power. The circuit must use not less than a #12 wire, and it should be protected by a 15 A
,
time-delayed fuse.
Before connecting the charger to the outlet, verify that the electric current is rated the same as the current that is stamped
on the charger's nameplate. In order to reduce the risk of the charger cord disconnecting from the extension cord during
use, make a knot as shown in Fig. C.