17
®
/MD
model no. 060-0583-8 | contact us: 1.866.523.5218
PROBLEM
POSSIBLE CAUSE
SOLUTION
The handle is not in position.
The bolts are not properly seated.
Make sure the bolts are correctly
installed through the handle bars.
Check to see if the hand knobs
are tight. Refer to Assembling the
Handle, page 9.
The switch is defective.
Have the switch replaced by an
authorized service centre.
The snowblower does not start.
The extension cord is not connected
to the plug.
The extension cord is not connected
to the power source.
Connect the plug on the snowblower
to the extension cord.
Plug the extension cord into a live
120 V AC, 60 Hz outlet.
The motor is on, but the impeller
does not turn
The belt is damaged.
Replace the belt. Refer to Replacing
the Belt and Pulley, page 15.
The snowblower leaves a thin layer
of snow behind
The scraper is worn.
Inspect the scraper for wear or
damage. Replace the scraper. Refer
to Replacing the Scraper Bar, page
15.
Troubleshooting
