8
Plate Compactor
»
Operator’s Manual
Filter Seat
This plate compactor was partially assembled at the factory. To assemble your machine follow the below instructions.
ASSEMblY
HANDLE
AIR FILTER
1. Unfold the handle. (See
Figure 3a
)
1. Put the filter sponge element and filter core element into the
filter cover in order. (See
Figure 2a
)
2. Slide the two tongue of the filter cover into the slots of the
filter seat. (See
Figure 2b
)
3. Align the bottom hole in the filter cover and the hole in the
filter seat. Fasten them together with screw. (See
Figure 2c
)
2. Mount the handle as shown. Slide the handle ends into the
engine deck slots. (See
Figure 3b
). Secure with the flat washers,
nuts and bolts found in packet #1 of the hardware kit.
3. Unwrap the throttle cable from around the top of the engine.
4. Unscrew bolt 5×35 from throttle control. Secure the throttle
control onto the upper handle with a flat washer 5 and the bolt
5×35 that just were unscrewed. (See
Figure 3c, illustration 1 & 2
)
5. Fasten the throttle control cable with cable fasteners.
Figure 3a
Figure 2a
Figure 2b
Figure 2c
Figure 3b
1
2
M5
(×1)
Lower Handle
M10 × 70
(×2)
Upper Handle
16
mm
15
mm
16
mm
15
mm
Assembly
|
Screw
Filter Cover
Filter Sponge Element
Filter Core Element
29140US25M100.indd 8
2017/3/20 13:50:23
