7
S5
Step 3 -Attach Panels to Posts
1. Place panel assemblies on posts as shown (Fig.1) allowing a 4” gap between the bottom of the post and the
bottom edge of the bottom rail on the panel assembly.
Note: This is best achieved by laying a 4x4 post on the
ground. Position panel assembly correctly in place. Once attached, stand the post and attach assembly with
the completed posts and panel assembly pieces.
2. With a 1/8” drill bit, predrill holes as shown in fi gure 2.
3. Fasten the panel assembles to the post and Panel Clips with a S5- 1” Pan Head Screw provided in location of
arrows. (Fig. 1)
4. Repeat until all four pergola bases are assembled.
x2
Fig. 1
Fig. 2. Predrill Holes and Fasten
with S5- 1” Pan Head Screw
12x
1” Pan Head Screw
(10.2cm)
(10.2cm)
