background image

YG03MAN-REV 01.17-DATE 9/2017

6

WARNING:

The alarm needs to be thoroughly tested

prior to being used as a safety aid. Failure to do so

may result in injury or death. If the alarm does not

pass the test, please first look at the troubleshooting

in the test section or in the Troubleshooting Guide. If

failure continues, please contact the manufacturer at

732-730-9880 for assistance. 

Testing the Alarm

Test the siren by pressing the TEST button on the

bottom, right, front corner of the alarm (FIG 5). 

Pass: The alarm will give off a loud audible siren

when the button is pushed.

Failure 1: No sound is heard. Ensure the battery is

new and is installed properly. Test the alarm again. 

Failure 2: Low audible sound with clicking noise.

Ensure the battery is new and is installed properly.

Test the alarm again.

Bypassing the Alarm to Enter

1. Press the PASS/RESET button on either the front

of the alarm or by using the attached PASS/RESET

pad (FIG 16).

2. Open the door/gate/window.

3. Close the door/gate/window within 15 seconds.

The alarm will start to beep (4 individual beeps and

then 3 series of multiple beeps). The alarm provides

15 seconds for the user to pass through the entry

way. The series of multiple beeps informs the user

that the alarm is about to sound.

If the door/gate/window is not closed within 15

seconds, the alarm will sound.

OPERATING THE ALARM

IMPORTANT:

When the alarm sounds, go to the

alarm immediately and inspect why the alarm has

sounded.  Ensure the area and all persons are safe.

Contact emergency personnel when necessary.

When the alarm sounds, the siren will be loud and

continuous. If the alarm is not properly set in the

ready state, the siren will continue to signal the

alarm. 

1. Inspect the area to ensure it is safe and there is no

presence of danger for anyone in the area, especially

children or those that cannot swim.

2. Close the door/gate/window so that the magnet

and the sensor are aligned properly.

3. Press either of the PASS/RESET buttons (FIG 17).

4. The alarm will be silenced. 

Silencing the Alarm

Features of the Alarm

FIG. 17

FIG. 16

Immediate Alarm Signaling

- The YardGard is

always in the ready or ON position. If the alarm is not

temporarily bypassed by pressing the PASS/RESET

button, the alarm will immediately signal that

unwanted entry has been made. 

4 Minute Auto Reset 

- The alarm will automatically

reset if the entry way is opened and then closed. The

siren will sound for 4 minutes continuously if the entry

point is opened and then closed without the

PASS/ENTRY button being pushed. If the entry point is

not closed properly, the alarm will continue to sound.

Содержание YG03









Отзывы: