YG03MAN-REV 01.17-DATE 9/2017
5
1. Identify the location where the alarm will be
installed.
IMPORTANT:
Ensure there is a space of 7" in height
and 2.5" in width to accommodate the alarm and
sensor at the installation location. Account for
locking mechanisms or handles.
2. Using a measuring tape, measure a minimum of
54" from the ground on the stationary point opposite
of the window or door (Ex. molding or casing) (FIG 6).
3. Place the bottom of the mounting plate at or above
the 54" mark and secure it to the casing using 2 of
the larger screws or adhesive pads.
4. Once the mounting plate is secured, place the
alarm into the mounting plate and slide downward
until an audible click is heard (FIG 8).
5. Mount the sensor under the alarm using 2 small
screws or pads.
6. Place the magnet on the door or window frame
opposite of the sensor, ensuring the dots on the
components are in-line. Attach using 2 small screws
or foam adhesive* (FIG 10).
IMPORTANT:
The space between the magnet and
sensor cannot be more that 0.75". The magnet and
sensor can be placed at a 90 degree angle from each
other to accommodate a window or slider
installation.
*Foam adhesive pad can be used for installation on
glass.
7. Place the PASS/RESET pad attached to the main
body alarm on the outside of the door and attach to
the casing using 2 large screws or pads (FIG 11).
NOTE:
Accommodations for door framing may have
to be made. If installing on a window, the
PASS/RESET pad can be mounted inside next to the
alarm body.
8. Cover all screw holes using the provided plastic
caps (FIG 12).
9. The alarm is now installed, move to the Operation
Section of the manual.
6. Attached the sensor to the post, under the alarm
body by using nylon straps (FIG 15).
7. Attached the magnet to the plastic spacer by using
2 small screws.
8. Place the magnet on the gate post/frame opposite
of the sensor, ensuring the dots on the components
are in-line. Attach using nylon straps.
IMPORTANT:
The space between the magnet and
sensor cannot be more that 0.75".
9. Place the PASS/RESET pad attached to the main
body alarm on the inside of the fence and attach
using adhesive pads (FIG 11).
10. Cover all screw holes using the provided plastic
caps (FIG 12).
11. The alarm is now installed, move to the Operation
Section of the manual.
Installation for Doors and Windows (On Casing or Wall)
FIG. 13
FIG. 14
FIG. 15
