Step 5.
Fasten the side tabs of the bracket using 1 3/4” washer head
screws.
Step 6.
Attach the swing beam bracket (3G) to the end of the beam
without the end caps.
Use two 4 7/8” threaded rods with washers and acorn nuts to
fasten the bracket.
Step 7.
Install the beam strap (3E) on the other end of the beam using the
same 4 7/8” threaded rods.
Only finger tighten the nuts at this point.
Step 4.
Pre-drill four 1/2” holes then attach the bracket using the included
lags.
