Yard force Y0LMX21P300, Руководство оператора

Страница: 12 / 13

22 23
MAINTENANCE AND STORAGE
BATTERY MAINTENANCE:
Use the following procedures to enable optimum usage of the battery:
1. Protect the battery against moisture and water.
2. Store the battery only with in a temperature range from 32˚ F to 113˚ F. As an example, do not leave the
battery in the lawn mower in direct sunlight.
3. Clean the battery occasionally with a soft, clean and dry brush.
4. If you do not use the product for a long time, please charge and discharge the battery pack once every
6 months.
STORAGE AND TRANSPORT (See fig. 22)
Fig. 22
After cleaning the unit thoroughly, store it in a dry room and allow the motor to cool down.
1. Release the Handle Quick release levers, and fold the handles down.
2. Position the lower handle lock pin into the mower bracket. Lock the handles in place by closing the
Quick release handle.
NOTE:
Remove the safety key and battery packs. Ensure cables are not trapped when folding/unfolding
the handle. If stored vertically –Make sure it is position in a corner so that the blade is facing
inwards to a wall and it is secure to prevent accidentally falling over.
TRANSPORT
Use the original packaging to ship whenever possible.
TROUBLE SHOOTING
WARNING! Before performing any repair work, always ensure that the battery pack/safety key has
been removed and wait until the blade has stopped completely and the tool has cooled down.
WARNING! Always wear heavy duty gloves when adjusting or cleaning, especially when handling
sharp objects.
Fault/malfunction Cause Remedy
Mower fails to start
Safety key is not inserted Insert safety key
Battery is not correctly inserted Remove the battery and reinsert
Mower standing in high grass
Start motor on shorter grass or
already mowed area ;change
cutting height if necessary
The mower housing is clogged
Clean housing so that the blade
can move freely
Battery has no power check and recharge battery
Mower stops working /loses
power
Cutting height is improper Adjust the cutting height
Discharge chute/ housing is
blocked
Clean the discharge chute/ housing
Cutting blade is worn or damaged
Replace with New blade from
dealer service center
Battery performance decreasing
Mower Overloaded -Red light
displayed switch box
Check the battery performance and
charge it if necessary
Wait until reset occurs – Green light
displayed on switchbox
Grass bag is not filled sufficiently
Cutting height is too Low Adjust and increase cutting height
The lawn / grass is wet Allow the lawn to dry
Discharge chute/ housing is
blocked
Clean the discharge chute/ housing
Underside of the mower deck is
clogged. Clean the underside of the mower
deck
Cutting blade is worn or damaged.
Replace it by the customer service
center
Mower vibrating at higher speed
Cutting blade is unbalanced
Balance the blade by grinding each
cutting edge equality
Blade is Loosened /incorrectly
fitted
Tighten the blade bolt
Mower does not mulch properly
Cutting height set to low
Deck has wet grass on underside
of deck Adjust cutting height
Clean underside of deck and wait
until grass is dry
Mower cuts unevenly
The blade is damaged
Blade is assembled incorrectly Sharpen the blade or replace
Re-assemble blade correctly