44
45
Status indicator LEDs
Lift signal
A red LED above this symbol shows that the lift sensor has triggered.
Note: Vibrations or collisions can also trigger the lift sensor.
If this sensor is triggered for less than one second, the Robomower will resume its work
schedule immediately.
When triggered more than 1 but less than 8 seconds, it will only restart working after a
brief pause. In case the lift signal last more than 8 seconds, the Robomower's
anti-theft system triggers. The device will lock itself and an alarm will sound.
Boundary wire signal
The boundary wire emits an electromagnetic signal. The Robomower uses this
signal to determine if it is within the cutting area.
The red LED above this symbol flashes when the device does not receive the "within
boundary" signal. In this case, the Robomower stops mowing immediately.
Low battery remain symbol
This LED will turn on when the battery charge is low. In this case, the Robomower will
immediately return to the charging station.
Charging
This LED will flash while the battery is charging. A continuous LED indicates a fully
charged battery.
While charging, the boundary signal receiver is powered off to save energy. This can cause
the "boundary wire signal" LED to turn on.
Working time setting
The above buttons let you choose the mower's daily working hours.
Please refer to the below table for the recommended working time per day, depending on the
working area.
The currently set working time is indicated by the illuminated button.
A flashing button means that the device has already worked the respective hours that
day.
Note: The average working time with a fully loaded battery is less than the minimal working
time setting of 4 h. When the Robomower returns to the charging station, the clock does not
stop. The charging time counts as working time.
Recommended time per day(hour)
300m
2
4 hours
500m
2
6 hours
After the working time is selected, the corresponding LED will be lit up LED flash means out
of working time.
Signal setting
To avoid interference with a second Robomower, there are two different boundary signals
available.
Be sure to choose the same signal (S1 or S2) for the charging station and the Robomower.
Use the control at the back of the charging station to switch between signal S1 and S2.
F
B
OPERATION
OPERATION
