16
17
Hotline: 1-866-902-9690
Hotline: 1-866-902-9690
Flowerbeds
Use the boundary wire to exclude any flowerbeds from the cutting area. There are two options for the two
lengths of boundary wire running between the flowerbed and the outer boundary:
1) Keep the distance between the parallel wires above 2 in. This way, the Robotic Mower will recognise the
boundary wire as an ordinary obstacle. When cutting, it will "bounce" off it as usual. When following the
boundary wire back to the docking station, it will take the detour around the flower bed.
> 5 cm
> 2 in
>
2 in
2) Alternatively, keep the distance between the two parallel wires below 2 in. Do not cross the wires - see
below. This way, the Robotic Mower will not recognise the wires and travel across them unhindered. This
option requires placing an obstacle on the boundary wire around the flowerbed. Place the obstacle, e. g. a
large rock or pole, near position A indicated on the below illustration. The obstacle must be surrounded by
a flat area of about 3.3 ft X 3.3 ft, without any slopes. This obstacle will allow the machine to exit the circle.
< 2 in
<
2 in
A
Ponds and Pools
While the Robotic Mower is protected against rain and spray water, being submerged is likely to cause
severe damage to the electronic parts.
Therefore, it is imperative to exclude any pools from the cutting area. For added safety, we recommend
placing a fence around the pool.
Inventory and garage
If you have created a boundary corridor inside your working area, the corridor should be at least 6.5 ft wide
and a max length of 26 ft.
If a corridor is too narrow or too long, the Robotic Mower might not be able to navigate it from one end to
the other.
< 26 ft
> 6.5 ft
Connect the docking station to the boundary wire
Run the boundary wire underneath the front of the docking station and connect the end of the wire to the
left (black) connector marked 'F' (front). After you have placed the wire around the garden then place the
other end into right (red) connector marked "B" (back).
0.4-0.6 in
Insert the mains plug into a properly installed socket. Once the blue LED confirms all is OK, test the
Robotic Mower's function. Check the LED regularly to ensure fixing the boundary wire has not affected the
connection and signal shows S1 on the charging satation. Then place the Robotic Mower in the working
area, a few metres beside the docking station. Set the main power switch to "ON". and then check the S1
signal on the panel is light on, press4 times
to unlock the panel.
OFF (released)
ON (pressed)
Four times
ASSEMBLY
ASSEMBLY