Yard force ProRider E559, Инструкция по эксплуатации

Страница: 11 / 23

20 21
INSTALLATION
TOOLS NEEDED
The following tools (not included or drawn to scale) are needed for assembly:
UNPACKING
• Remove the hardware securing the corner and side braces to the frame bottom, then lift the braces to
remove.
WARNING!
Do not discard the hardware to avoid any personal injury.
• Cut the nylon straps securing the front and rear wheel axles to the frame.
• Remove and set aside all accessible packaging and wrap from unit and parts. Do not discard the
packing material until you have carefully inspected and satisfactorily operated the product.
WARNING!
If any parts on the Parts List are already assembled to your product when you unpack it, verify
the part is assembled correctly, are properly tightened, and is torqued correctly (where applicable)
before proceeding to the next assembly step. Use of a product that may have been improperly
assembled could result in serious personal injury.
• Inspect the product carefully to make sure no breakage or damage occurred during shipping.
• If any parts are damaged or missing, please call Yard Force customer service.
NOTE: Mower should be assembled while positioned on the frame bottom. Once assembly is complete,
raise the cutting deck to its highest position. Position a board such as a standard 50x100 mm along the
front of the pallet to create a gradual transition between the frame and the ground. Slowly drive the mower
forward.
WARNING!
Use care when driving the mower off of the frame and press the brake pedal as needed to
control the speed. The mower will freely roll if it is moved on an inclined surface without
pressing the brake pedal or setting the parking brake. Failure to follow these instructions
can result in loss of control and result in death, serious personal injury, or property damage.
NOTICE!
Driving the mower off the frame in the forward direction without a transition board can
cause damage to the mower’s cutting deck.
TORQUE WRENCH
20
30
40
0
50
TIRE PRESSURE GAUGE
SOCKET WRENCH WITH 12 mm
AND 14 mm SOCKETS AND 6 mm HEX BIT
INSTALLATION
ASSEMBLY
WARNING!
Strictly adhere to all torque wrench tightening specifications. Failure to do so could cause
serious personal injury.
WARNING!
Do not attempt to modify this product or create accessories not recommended for use with
this product. Any such alteration or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING!
To prevent accidental starting that could cause serious personal injury, always remove the
start key from the tool when you are assembling parts.
CONNECT THE BATTERY
When shipped from the factory, the mower’s batteries are disconnected. To connect:
• Press the tabs on the wiring cover and lift the cover to remove.
• Connect the two ends of the battery quick-connect plug together.
NOTE:
Before reinstalling the wiring cover, install the seat as described in the next section.
INSTALL THE SEAT
• Remove flange nuts and bolts from seat mounting brackets.
• Place the seat assembly over the mounting brackets and align holes as shown.
• Reinstall flange nuts and bolts and tighten securely (torque 8 Nm).
• Route seat safety interlock cable through hole in wiring cover, then attach to plug on mower.
• Reinstall wiring cover and make sure it is securely seated.
1
2
Mounting Bracket
Bolt
Flange Nut
Wiring Cover
Tab
Tab
Battery
Quick-
connect
Plug
Battery
Quick-
connect
Plug
Wiring
Cover
(A)
(B)