20
21
Inflating with the air hose and adapters (Fig. H)
1. The air hose (10) can be used with adapters to inflate different objects.
2. Insert adapter into the air chuck (1) and it locks into place.
Switching on and setting the digital pressure gauge (Fig. I)
1. The digital pressure gauge can be used to set the pressure of the inflated objects and
monitor the pressure inside the inflated object.
Press the power button (15) to switch on the digital pressure gauge.
2. To switch between PSI, BAR or KPA modes
- Press the digital pressure gauge power button (15) to select the desired measured unit.
Setting digital pressure gauge for automatic shut off
1. With the digital pressure gauge (12) switched on, press and hold down (+) or (-) button to
select desired shutoff pressure.
Note:
Numbers will flash while setting pressure. Holding buttons down will make the
pressure number increase or decrease faster.
2. When the desired pressure has been selected, begin inflating. The air pump will shut off
once the set pressure is reached.
LED worklight (Fig. J)
1. The LED worklight (7) will switch on when the power button (15) is pressed.
2. The LED worklight (7) will stay on when the air pump is switched on. When the air pump
is switched off, the LED worklight will turn off after 30 seconds.
Starting and stopping (Fig. K)
1. To switch the air pump on, press and hold the power and mode button (15) till the digital
pressure gauge (12) is on.
2. Once the digital pressure gauge has switched on, select the desired shutoff pressure.
3. Depress and hold the trigger switch (6) to start pumping air.
4. After a few seconds release the trigger switch (6) and the air pump will continue running.
The air pressure will appear on the digital pressure gauge (12) as the object is being
inflated.
5. To turn the air pump off, press the trigger switch (6) again.
6. After the pre-set pressure is reached, the air pump will turn off automatically.
OPERATION
MAINTENANCE AND STORAGE
Cleaning
1. Regularly clean the air pump's housing with a soft cloth, preferably after each use. If the
dirt does not come off, use a soft cloth moistened with soapy water.
2. Never use solvents such as petrol, alcohol, ammonia water etc. These solvents may
damage the plastic parts.
Maintenance
1. The air pump has been designed to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation depends upon proper care and
regular cleaning.
2. The air pump should only be repaired by an authorized service centre. There is no
serviceable parts that can be repaired by the user.
Storage
1. Thoroughly clean the air pump and its accessories before storage.
2. Store the air pump and its accessories out of the reach of children in a stable and secure
place.
Disposal
Dispose appliances according to the regulations and requirements of your local
council. If appliances are disposed in landfills or dumps, hazardous substances
may leak into the ground water and get into the food chain, damaging your health
and well-being.
TROUBLESHOOTING
Problem
Possible causes
Possible solutions
Air pump cannot
start.
Battery not installed
properly.
Insert the battery again.
Battery not charged.
Charge the battery.
No pressure.
Adaptor not fitted properly.
Fit the adaptor properly.
Pump is not working.
Repair by an authorized
service centre.
Pump operates but
object does not
inflate.
Adaptor is not fitted
properly.
Fit the adaptor properly.
Adaptor is not clean.
Clean the adaptor.
Incorrect adaptor.
Use the correct adaptor.
Содержание LX CAP1
Страница 2: ...2 3 A B 11 1 2 12 15 14 13 3 12 9 8 7 6 5 4 c g h e f d b a...
Страница 3: ...4 5 C K E G F H D I J 1 3 2...