![background image](http://html1.mh-extra.com/html/yard-force/lw-cpc1/lw-cpc1_original-instructions-manual_905875012.webp)
22
23
OPERATION
Installation
Assembly of the handle and housing
1. Align and insert the upper tube with the lower housing tube as shown in
Fig C
(make
sure the connecting cable is not twisted)
2. Rotate the Locking collar clockwise until the lock collar is fully secured in place.
3. Check the upper and lower are fully locked & secured in place.
Adjust Auxiliary handle (Fig. D)
1. Release the locking lever.
2. Rotate the auxillary handle and adjust the position of the handle on the tube.
3. Now close the locking lever to fully lock the handle into position.
Initial startup
1. Close the water volume regulation valve.
(Fig. E)
2. Connect the water hose to the device. The coupling must audibly engage fully.
3. Secure the water hose to the hose hook.
(Fig. F)
4. Connect the water hose to the water tap and open the water tap. Please observe the
maximum water pressure (see "Technical data").
(Fig. G)
Charging the battery pack
NOTE:
Remove the battery pack from the charger after it has been fully charged.
NOTE:
Battery should be fully charged before first use.
NOTE:
Make sure the mains voltage is the same as rating label which is located on the
charger.
1. Connect the charger to a power supply. Red LED will light up.
2. To insert the battery pack into the charger, align the raised ribs of the battery pack with
the grooves of the charger then push it in.
(Fig. H)
3. The red LED light of the charger will go
off and then the green light flashes during normal
charging.
4. After charging is complete, the charger light will turn to a solid green light.
5. Once the battery is fully charged ,remove the battery pack.
Battery power indicator (Fig. I)
This Li-Ion battery pack is equipped with a power indicator which is used to show the battery
pack’s remaining charge. Press the power indicator button to check battery charge as picture
showed. The indicator will stay lit for approximately 4 seconds.
OPERATION
To obtain the best life from the battery
1. Never allow the battery to completely discharge before recharging. The battery pack
should be placed on the charger whenever the battery pack is noticeably running down
or the tool no longer performs a task it previously performed.
2. Avoid conducting short charges. Make sure that the battery is fully charged each time by
allowing the charger to complete its full charging cycle.
3. Avoid allowing loose items like screws or nails etc. to be stored with battery packs as
these or similar items can short battery packs and cause a fire or explosion.
4. Always unplug the charger when not in use and store in a dry and secure place.
5. Avoid charging or storing your battery in temperatures below 5 °C and above 45 °C.
6. After use, allow the battery pack to cool down for approximately 30 minutes before
attempting to recharge.
Attaching/Detaching the battery pack
Fully charge before first use.
To Attach
Align the battery ribs with the mounting slots and push the battery pack into place until you
hear a “click”.
(Fig. J)
To Detach
(Fig. K)
Depress the battery release button and remove the battery pack
Before operating, look around you to ensure a safety working area without other people,
animals or any loose objects. And then check for eye protection, proper clothing and
balanced footing.
Before starting
1. Select the speed and cleaning direction, default high speed, forward cleaning
.
(Fig. L)
2. Open the water volume regulation valve.
(Fig. M)
Switching ON/OFF the device
(Fig. N)
1. Depress the safety lock off button
2. Depress the Power ON/OFF lever
3. Release the Power ON/OFF lever to stop the device
Forward
Direction
Reversed
Direction