24
25
Parts description (Fig. A)
1. Chain safety guard
2. Oil tank cap
3. Battery pack release button
4. Battery pack
5. Oil tank
6. Guide bar
7. Saw chain
8. Side cover
9. Side cover locking knob
10. Switch ON/OFF trigger
11. Allen key
12. Main handle
13. Safety lock off button
14. Chain bar cover
Delivery contents (Fig. B)
Carefully unpack the appliance and check that it is complete. Dispose of the packaging
material correctly.
a. 12V Mini saw (with chain bar cover)
b. Allen key
c. Battery pack
d. Charger
e. Instruction manual
f.
Chain oil
WARNING:
If any parts are damaged or missing, do not operate this tool until these
parts are replaced. Failure to heed this warning could result in serious personal
injury.
NOTE:
Always recycle the packaging in accordance with local recycling guidelines.
DESCRIPTION OF PRODUCT
OPERATION
Charging the battery pack
NOTE:
Remove the battery pack from the charger after it has been fully charged.
NOTE:
Battery should be fully charged before first use.
NOTE:
Make sure the mains voltage is the same as rating label which is located on the
charger.
1. Connect the charger to a power supply.
2. To insert the battery pack into the charger, align the raised ribs of the battery pack with
the grooves of the charger then push it in.
(Fig. C)
3. The green LED light on the battery pack will flash continuously during normal charging.
4. After charging is complete,
the four green LED light will light up.
Power indicator (Fig. D)
This battery pack is equipped with a power indicator which is used to show the battery
pack’s remaining charge. Press the power indicator button to check battery charge as picture
showed. The indicator will stay lit for approximately 4 seconds.
To obtain the best life from the battery
1. Never allow the battery to completely discharge before recharging. The battery pack
should be placed on the charger whenever the battery pack is noticeably running down
or the tool no longer performs a task it previously performed.
2. Avoid conducting short charges. Make sure that the battery is fully charged each time by
allowing the charger to complete its full charging cycle.
3. Avoid allowing loose items like screws or nails etc. to be stored with battery packs as
these or similar items can short battery packs and cause a fire or explosion.
4. Always unplug the charger when not in use and store in a dry and secure place.
5. Avoid charging or storing your battery in temperatures below 5°C and above 45°C.
6. After use, allow the battery pack to cool down for approximately 30 minutes before
attempting to recharge.
Filling bar and chain lubricant (Fig. E)
NOTE:
The chain saw is not filled with oil at the time of purchase. It is essential to fill the tank
with chain oil before use.
The chain is automatically lubricated with chain oil during operation.
1. Position the device on a flat place with its oil tank cap facing towards.
2. Clean the cap as well as the area around and then turn it anti-clockwise to remove.
3. Carefully pour the specifically designed oil into the tank until reaching the Max line.
4. Wipe off any excessive oil and replace the cap.
WARNING:
Only use chainsaw chain oil on this product.
