Yard force ET U25, Оригинальное руководство пользователя

Страница: 19 / 25

19
OPERATION
Tilt adjustment
Adjust the vertical angle of the trimmer head to fit the trimming conditions.
1. Press the tilt adjustment pedal down with your foot.
2. Adjust the angle of the pole, up or down.
3. Release the unlock pedal and keep moving the pole until it locks in place.
NOTE:
Always ensure that the pedal snaps into place after adjusting the trimmer in one of the
three positions!
Edging
1. Adjust the vertical angle of trimmer head to 0 degree by pressing the tilt adjustment
pedal.
2. Adjust the trimmer head to 90 degrees for edging by pressing the locking button.
3. Twist the plant protector to an angle of 90°.
Automatic line feeding
The equipment features a fully automatic single line system. The lines will automatically
elongate every time you turn on the appliance. To support proper line elongation, ensure that
the coil has stopped moving completely before turning on the appliance again.
The lines are automatically cut to the correct length by the line cutter.
Trimming
1. Ensure the knife protector label is removed before use. Ensure you wear gloves when
removing this label.
2. Adjust the trimmer head angle to a proper position for trimming operation.
3. Hold the grass trimmer firmly, keeping your balance with feet slightly apart. Alter the
height of the product if needed to ensure an upright posture.
4. Hold the trimmer head just above the ground at an angle of approximately 30°.
5. Move the product slowly from side to side in a swinging motion.
6. Ensure the cutting device remains clean and free from off-cuts that may cause it to jam.
Check regularly. Release the on/off switch and take the battery pack off before checking.
7. Trim longer grass in stages; do not cut long grass in one cut. For the best results, cut
longer grass in steps.
90 90
oo
90 90
oo