8
9
GB
GB
Insert the mains plug into a properly installed socket. Once the blue LED confirms all is OK, test the
Robotic Mower's function. Check the LED regularly to ensure fixing the boundary wire has not
affected the connection and
signal shows S1 on the charging satation. Then place the Robotic
Mower in the working area, a few metres beside the docking station. Set the main power switch to
"ON".
Press the buttons
and
, a few seconds later, the Robotic Mower should automatically
return to the docking station by locating and following the boundary wire in anti-clockwise
direction. If Robotic Mower fails to dock correctly, move the docking station to a more suitable
position.
Once the device has docked, the symbol will start flashing. This indicates that the battery is charging
correctly.
S1
S2
After initial installation, the Robotic Mower will remain in the docking station until the battery is
fully charged.
Successful docking and charging indicates that you have found a suitable position for the docking
station. You should now drive fixing pegs into ground fully.
Take care not to damage or kink the surplus wire stored under the docking station.
Signal selection
Note:
the default signal is S1, no need to change the signal when there isn’t a influence signal
form the neighbors.
S1
S2
S1
S2
If your neighbour is using the samer, will need to keep a distance of 0.5m between you and your
neighbour's boundary wires to prevent the two devices interfering with each other. Ensure to
position your docking station at least 10m away from your neighbour's boundary wires and that both
products are using different signals. Please refer to section "Signal setting" in order to select signal
S1 or S2 for your installation.
1.
Press the “signal” button on the charging station, the indicator will be switched to S2.
2.
Turn on your robot mower, push the mower into the charging station, after 5 seconds, the
mower will be switched S2 automatically.
>10 m
>10 m
>0.5 m
S1
S2
Note:
if your mower can not be switched to the right signal after stay in the charging station, signal
switch could be set manually.
1.
Press and hold the button ”6H” and then switch on the mower for 5s, after 5 times beep, signal
is switched from S1 to S2.
2.
Press and hold the button “3H” and then switch on the mower for 5s, after a long beep, signal
is switched from S2 to S1.
1
2
