Lx410/450/490 Operator's Manual
1. Before connecting/disconnecting, adjusting,
cleaning or servicing Power Take Off (PTO)
driven implement, ensure that all the moving
components are not moving.
2. Make sure that Power Take Off (PTO) shaft cap
is always in place. Replace Power Take Off
(PTO) shaft cap only when the shaft is not
moving.
3. Before installing or operating the Power Take Off
(PTO) driven implement, carefully study the
Operator's Manual
of the implement and the
safety decals on the implement.
4. When installing stationary Power Take Off (PTO)
driven implements, ensure to engage the parking
brake securely, for details, see "6. Lock and Set
the Parking Brake" on page 7-4, chock all the
tires safely and securely. Avoid approaching or
accessing any rotating component.
5. Make sure to remove the drawbar before using
the Power Take Off (PTO).
1. Use the 3-point hitch only in conjunction with the
implement that is specifically designed for use
with the 3-point hitch.
2. Before using the 3-point hitch mounted
implement, the appropriate weight may need to
be installed on the front of the tractor.
3. While on a road, do not attempt to operate an
implement. During transportation, place the 3-
point hitch control lever in the raised position and
lock the 3-point hitch control lever with the
position stop knob.
Do not fully close the hydraulic flow control/stop
knob to hold an implement in the raised position
while the tractor is traveling with the implement.
The preceding action can cause damage to the
hydraulic lift circuit.
The tractor is equipped with a Roll-Over Protective
Structure (ROPS) which must be maintained in a fully
functional condition. Check overhead clearance
carefully before driving under power lines, wires,
bridges or low hanging branches, before entering or
leaving buildings, or in any other situation where the
operator and/or Roll-Over Protective Structure
(ROPS) can be struck, which can result in serious
injury.
1. Always keep the Roll-Over Protective Structure
(ROPS) on its original condition.
2. Replace the Roll-Over Protective Structure
(ROPS) whenever the Roll-Over Protective
Structure (ROPS) has been damaged. The
preceding action can weaken the structure and
endanger the safety of the operator.
3. Use only genuine parts to replace any damaged
part/s of the Roll-Over Protective Structure
(ROPS).
4. Never attach ropes, chains or cables to the Roll-
Over Protective Structure (ROPS) for pulling
purposes.
5. Although the Roll-Over Protective Structure
(ROPS) provides the maximum protection
possible, always take necessary precautions.
8. Operate the Power Take Off (PTO)
9. Use the 3-Point Hitch
10. Roll-Over Protective Structure (ROPS) Precautions
