InstructionManual
YZ-X8
9
Check for wear on the brush head skirt.
Operating the machine
1. Turn the main power key to the position (I).
2. Pull down the suction scraper lifting lever to lower the suction scraper assembly to
the ground.
3. Step on the lifting pedal of the brush head to lower the brush head to the ground.
4. Turn on the water control knob.
5. Press the brush plate motor switch, and then press the suction motor switch.
6. Motor driven model: Adjust the speed control knob to your desired cleaning speed
Note:Itisrecommendedtouseacleaningspeedof45-60metersperminute.
Machine operation period
Warning: Fire or explosion danger.
Do not pick up inflammable materials or active metals.
1. Each cleaning path overlaps by 5cm.
2. Keep the machine moving so as not to damage the ground.
If after absorbing water, there is drag mark on the ground, wipe test tape with a rag
Remove the laksa.
Clean beforehand to prevent drag marks.
3. Do not operate the machine with a slope of more than 5% (3° ).
4. Forsafety:Whenusingthemachine,moveslowlyonslopesandslipperysurfaces.
5. If there is too much foam, pour the recommended antifoaming agent solution into the
sewage tank.
Note: Do not let foam into the filter to avoid damaging the vacuum motor.
The foam will prevent the filter switch from failing.
6. Use double cleaning to clean extremely dirty areas.
First lift the water absorbent steak for cleaning, let the solution soak for 3-5 minutes, then
lower the water absorbent steak and clean again.
7. Replace or rotate the baijie mat as necessary.
8. Observe the electricity consumption of the battery power meter (see "Battery power
meter").
9. Check the amount of remaining liquid through the tank level gauge.
About 10 litres per 10 minutes for conventional washing;
10. When the water tank runs out of solution, empty the sewage tank and refill the
solution.
11. When staff leave the machine, please park it on the level floor and take out the key.
After cleaning, perform daily maintenance procedures.
