YANGZI YZ-X1, Руководство по эксплуатации

Страница: 10 / 12

9
Method: Remove the sewage pipe from the pipe clamp in an appropriate place, open the
pipe cover, and drain the sewage into the sewer
And wash the sewage tank.(See picture on the right)
(2) If the water level in the sewage tank is not high, and there is no excessive foam, please
check the connection between the suction scraper and the hose, it is likely to be blocked
by sundry here, after the removal can be restored to normal;
If the water level in the sewage tank is not high, but there is a large amount of foam, it is
possible that your cleaning liquid added too much or you use the cleaning liquid is a high
bubblecleaning liquid, toadd an appropriate amount in the sewage tank
After defoaming agent can be used normally;
(4) If the above three cases are not, please pull out the suction pull on the straw, open the
suctionmachine, try theair inlet suctionis normal ifyou feel suction issmall, checkthe
suction pull connection pipe whether there is a blockage.
9. Replacement of brush plate:
(1) Installing the brush plate: put the brush plate of the device under the brush plate cover (if
using the needle plate, please put the brush pad device on the needle first
Put it on the plate), put down the brush plate pedal so that the brush head and the brush
platebayonet are basicallyaligned, andpress downthe control surface atthistime
Brush plate motor start button, the brush plate will be installed automatically with the
rotation of the motor, and then you can start the operation.
Manual installation is alsoavailable. Manual installation is recommended for employees
who are not skilled in operation.
(2) Dismount the brush plate: after you finish the work, raise the brush plate first, close the
switch of the brush plate, the motor stops rotating the brush plate by hand,
Remove the brush plate.
10. Battery replacement method:
Cut off all button switches, turn over the sewage tank;
(2) Loosenthe clampon the battery,removethe battery connection,take out and replace
the battery separately;(Figure below)
11. Maintenance of water absorption steak:
Water absorption pick is an important part of the washing machine, in the process of water
absorption because of the friction of the strip and the ground will make it
Wear, when the effect of water absorption is not good, the following inspection should be
made:
Whether there is foreign matter in the rubber scraper;
(Prepare a towel and wipe the stained tape at any time.)
(2) Whetherthereisdebrisblockageattheconnectionbetweensuctionandhose;
(Remove the connecting pipe orifice or remove the suction scraper to clear the blockage)
(3) Whether the Angle between the scraper and the ground is appropriate, can be adjusted