12
YZ-S3
Instruction Manual
Instruction Manual
Be careful!
Maintenance free battery charging (Figure 16)
Optional water adding function
Skirt height inspection and operation
16
17
After each use, when the warning light is on, charge the battery
to extend its life.
If you want to stop charging, you should first disconnect the
AC socket switch before disconnecting the DC socket.
After the charger is disconnected from the power supply,
the DC plug can be pulled out. Figure 16
DANGER!
Do not touch the battery terminals and the pins of the DC plug.
When the water inlet with water is on the right side of the control panel (FIG. 17), it is
in reverse time
The needle rotates to open the water cap to add
water. Figure 17
Special attention: when the temperature is lower
than 0
℃
, the water in the water tank should be
drained after use.
1. Place the machine on a level ground suitable for checking the skirt height.
2. Turn the start key of the machine door to "off" position. Check the side skirt
3. Check the integrity of the side skirt.
4. Check whether the height between the side skirt and the ground is 0 ~ 3mm.
Check front / rear skirt
The front wheel of the sweeper is cocked up.
Check the front and back hems.
inspection
the front skirt gently touches the ground, but is not detached from the ground.
the height between the back skirt and the ground is 0-3mm.
