8
YZ-S3
Instruction Manual
Instruction Manual
Precautions for machine operation
The machine stops
Press the main brush and side brush function buttons to o position.
Turn the start key to the "off" position.
Note:
in the process of work, determine whether to start the vibration device
temporarily according to the amount of garbage on the ground to be cleaned.When the
filter is clogged or the dustbin is full, the machine cannot collect garbage. The dustbin
must be emptied after each operation. (if the dustbin is full at work, please empty it
immediately)
If the temperature is lower than 0 ℃ , please pay attention to drain the water in the box
to prevent freezing damage.
DANGER!
Avoid stopping the machine and letting the brush roll for a long time in
the same place; this will leave unnecessary marks on the ground.
When collecting large garbage, please remember to lift the front wheel slightly before
moving forward. Pay attention to lifting it only for a short time.
In order to clean the machine well, the filter must be cleaned. Pull the dust vibrating rod
on the side of the dustbin for more than ten times to shake off the dust on the filter.
look out!
When working, it is decided to clean the dust on the filter according to the
dirt in the cleaned area.
The dustbin must be emptied after each work and after it has been filled.
When the main brush and side brush are worn, the screw at the tail of the machine can
be adjusted to lower the main brush and side brush. It is not allowed to adjust it too
low. Clean it to avoid burning out the fuse.
(there is no need to adjust when cleaning for the first time. The staff of our company
have adjusted it)
empty trash
Push the sweeper to the bin dump.
Release the buckle and take out the dustbin (Fig. 5).
After cleaning the garbage, put the front of the dustbin on the rear baffle, and then lock
the buckle.
5
