YZ-GS1
Operating
Manual
Operating Manual
YZ-GS1
Part VI
Common phenomena and
treatment methods
1.
The brakes not working.
Adjust the inner wire rope nut on both sides clockwise to achieve the same braking effect on
both sides.
2.
Not walking.
Associated parts have controller (inside left side of distribution box), fuse (top
down second), two-way contactor (below the fuse), accelerator (right foot
tread), drive wheel
(Front wheel), battery, corresponding wiring jokes, connectors and clues. Damage or bad
contact with any of the parts will cause them not to walk, and replacing the damaged parts
can be restored.
3.
No cleaning
As for sweeping this main component, there are 2 side brush motors, 1 main brush
motor, 1 fan 1,100A contactor (middle on the right side of the distribution box), travel
switch (on the right side of the body,
Inside of the main brush connection plate, fixed to the right board), the main and side brush
push rod, wire rope, control switch buttons, etc. The travel switch is damaged or the
adjustment is not in place, the main brush push rod is damaged, the wire rope fracture, and
the control switch button burn will cause no cleaning. Side brush motor, main brush motor,
fan motor is controlled by 100A contactors, if any of them does not work, it is a motor fault.
If none work, the reasons are
The ① sweeping switch button fails, and replace the switch.
② sweeping travel switch fails, adjust the main brush wire rope to make the travel switch; if
the travel switch is damaged, it can be replaced
The ③ 100A contactor is damaged and can be replaced.
4.
No sprinkling
Sprinis mainly associated components, water tanks, water pumps, water pipes, valves,
nozzles, relays, switches and control lines.Common problems are water tank leakage,
water pipe rupture, not strict, nozzle blockage, water pump damage, electrical
and circuit failure, etc. If any joint is leaking,
Release the connection section, and then wrap the raw belt and tighten it.
5.
No charging
Check whether the charger connector is connected properly, whether the charger is working
properly, and whether the charger panel shows it as indicated in the instructions. If the
connector is not plugged in, do so. Other exceptions are found, such as insurance
The wire is blown and the charger does not display, please contact the aftermarket service
personnel in time.
Ash leak
Common ash leakage is mainly caused by the air filter element is not timely dust vibration
caused by blockage
① bin sealant strip falling off or partially damaged
The ② fan is not working properly
③ front flap damage
④ main brush has filament ribbon winding or wrong installation direction
⑤ bin buckle is loose or off
⑥ cleaning speed is too fast
If the above situation is found, please make the corresponding treatment measures according
to each situation.
6.
Main brush and edge brush cannot be promoted
Control the main brush, variable brush promotion is 3 putters, each work, joint control. If
1 or 2 of them are found not working, the putter can be damaged and replaced; if 3 are
found and do not work at the same time. Check its lines,
It can basically be judged that the button is damaged, and it can be replaced.
7.
Steering wheel failure
Under normal circumstances, the main reason for the failure of the steering wheel is the
loose or broken chain above the front wheel, and replace the chain in time. The ② steering
wheel connection spline is loose and tighten the spline locking screws. Flines are located in
the
Above the site, the bottom of the machine.
8.
Dust dust
Check whether the dust motor is damaged and whether the dust chain is loose or broken. If
damaged, replace it. Check whether the relevant lines and switch buttons are normal. If
damaged, replace them.
9
10
