12
Operation Method
Apparatus/Liquid Sterilization Course
Follow the procedures below for the setting of apparatus sterilization and liquid sterilization courses.
1. Pour the water to the designated scale in chamber, lay
the sterilization samples in place and close the cover,
as shown in the right figure, the green water level
indicator lamp, yellow lid lock indicator lamp and green
temp. indicator lamp light up.
2. Press key to shift the function light to the
position of sterilizing temperature, the sterilization
temperature indicator on the panel is light, the display
shows SP. The sterilizing temperature may be set as
required.
3. Press
▲▼
key to raise or reduce the temperature.
After adjusting to the required temperature, press
again to confirm the new setting and complete the
temperature setting procedures.
3. press key to shift the function lamp to the
position of sterilizing time, the sterilization temperature
indicator on the panel is light, the display shows ST. The
sterilizing time may be set as required.
4. Press
▲
key to increase the time and press
▼
key to reduce it. After adjusting to the required time, press
key another time to confirm the new setting and complete
the time setting procedures. The sterilizing time may be
set with reference to “Sterilizing Parameters”
5. The running light being on indicates the heater is
heating, and with the rise of temperature inside the
evaporation pot, the cold air inside the pot will be
released from the vent automatically.
Note
: The outside surface of this unit may get hot to the touch contact between unprotected skin and
outside surface of this unit during operation may cause burns. Always use protective gear to shield
operator from hot surfaces.