Cod. 94532 – MS1600-2
13
Read the manual instructions.
Switching on - switching off
- Brief activation Switching on: press ON/OFF switch 1. Switching off: release ON/OFF switch 1-
Continuous use
Switching on: press ON/OFF switch 1 and in pressed position lock it by button 2.
Switching off: press ON/OFF switch 2 once and release it immediately.
Electronic rpm control
Light pressure on ON/OFF switch 2 results in low rotation speed, further pressing the switch results
in smooth increase of the rpm to maximum upon reaching the extreme position.
Electronic speed pre-selection
The necessary speed can be pre-selected by rotating the regulator dial 3 to the direction of the
arrow or to the mark “+” for increasing, and to the direction opposite to the arrow or towards the
mark “-” for decreasing the speed, thus ensuring optimum mode.
Switching between 1st - 2nd gear (4)
The switch position enables you to work at high or low speeds. The gear switch position should only
be changed when the unit is stopped, in order to prevent the gearing from being damaged.
Mixer assembly
First screw mixer part (6A) together with part (6B). Screw the mixer (6) into the mixer holder (5)
afterwards. Use the two spanners to do this. Use one of the spanners (a) to hold the mixer holder (5)
in place and then use the second spanner (b) to tighten up the mixer (6). Proceed in the reverse
sequence to undo the mixer.
Recommendations
The mixing paddle is still rotating for a while after the machines has been switched off.
If the rotating paddle touches a surface, a rebound may result. Start the machine by slowly pressing
the switch trigger 2 to reach maximum speed only after the mixing paddle has already been dipped
into the mixture
Maintenance and repair
Unplug the machine prior to any procedures on the power tool.
Your power tool requires no additional lubrication or maintenance. Always store your power tool in a
dry placeI. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
Motor housing as free dirt and dust as possible. Clean the unit by rubbing it with a clean cloth or
blow it clean using low- pressure compressed air.
Always clean the unit immediately after using it.
Do not using cleaners or solvents, this will attack th aplastic parts in the unit.
You must also ensure that water cannot get into the inside of the unit.
