Yamato DC401, Инструкция по эксплуатации

Страница: 10 / 31

7
2. PRE-OPERATION PROCEDURES
Installation Precautions & Preparations
CAUTION!
6. Connect to a proper power supply.

Connect power cable to a suitable facility outlet or terminal, according to the following
electrical requirements.
Electrical
requirements: DC401: 220V AC, 50/60Hz, 2.6A (When used with pump & heater: 12A)
NOTE)

Check the line voltage on outlet or terminal to be used and properly evaluate whether to
utilize a line being shared by other equipment. If the unit is not activated by turning on
the main power switch (ELB), take an appropriate course of action, such as connecting
the unit to a dedicated power source.

If multiple power cables are connected to a single outlet, input voltage to unit may drop,
causing degraded cooling and temperature control performance.
7. Install in a safe location.

In the event of an earthquake or other unforeseen incident, equipment may unexpectedly shift
or fall, causing injury. Taking preventative steps to install unit in a safe location, away from
room access doors and out of other danger is strongly recommended.
8. Handle power cable with care.

Never operate unit with power cable bundled or tangled; and do not modify, bend, forcibly
twist or pull on power cable. Doing so may cause fire and/or electrical shock.

Do not risk damage to power cable by positioning it under desks or chairs, or by pinching
it between objects. Doing so may cause fire and/or electrical shock.

Do not place power cable near kerosene/electric heaters or other heat-generating
devices. Doing so may cause power cable insulation to overheat, melt and/or catch fire,
which may result in electric shock.

Turn off main power switch (ELB) immediately and disconnect from facility terminal or
outlet, if power cable becomes partially severed or damaged in any way. Failure to do so
may result in fire or electric shock.
Contact a local dealer or Yamato sales office for information about replacing power cable
if it is damaged.

Always connect power cable to appropriate facility outlet or terminal.