cod. 54503 - mod. PT 2000 N
Bonding and deforming synthetic materials
- Heat up synthetic materials by consistent see-saw movements. Use suitable hot
adhesives for bonding.
Drying
- The product can be used for drying coats of paints, binders and sealants.
Shrinking
- Select the shrink hose according to the workpiece and heat up evenly using the hot air
gun.
Thawing of water pipes
- Always heat up the frozen section from edge to middle. Exercise extreme caution when
heating up plastic pipes and joints between pipe sections in order to prevent damage.
Cap nozzles
WARNING!
Risk of injury!
The nozzle must not be replaced until the device has
cooled off and has been disconnected from the mains.
> The air-blast nozzle (G) protects panes of glass, for example, from being heated up by
diverting the air current.
> The reducing nozzle (H) produces a precise air current which can be used for deforming
synthetic materials, for example.
> The reflector nozzle (I) produces a flat air current which can be used for thawing frozen
water pipes, for example.
Check before switching on!
WARNING!
Risk of injury!
The product must only be put into operation if no
defects are found. It is crucial that any defective parts are replaced before the
product is used again.
Check the safe condition of the product:
- Check that the air inlet openings are not blocked.
- Check all parts to make sure that they fit tightly.
- Check whether there are any visible defects: broken parts, cracks, etc.
Switching on/off
NOTICE!
Risk of product damage!
Always maintain a minimum distance of 25 mm
between the nozzle and the surface to be treated.
NOTICE! Risk of product damage!
Never use the product with the air inlet
openings pointing downwards. Dirty air can be sucked in.
NOTICE! Risk of product damage!
The product must always be used with one of
the cap nozzles.
