13
Read this manual carefully before operation to avoid the hazards such as
electric shock, burn of fire.
•
The work area must be kept clean to avoid danger.
•
Pay attention to the environment, do not expose the tool in rain or humid place. Keep
work area lit up. Don’t use the tool in presence of inflammable liquid or gas.
•
Pay attention to do not touch the grounding parts, pipes, heat elements, so that to
avoid electric shock.
•
Take care of the tool. Put it in dry place when not in use, and far from children.
•
Don’t overload the tool. Operate only within the load level suggested.
•
Dress properly : Don’t wear loose clothing or jewelry because they can be caught in
moving parts. Rubber gloves and non-skid footwear are recommended when working.
Wear protective hair covering to contain long hair.
•
Use safety glasses and dust musk if operation is dirty.
•
Never carry the tool by cord or yank it to disconnect from receptacle. Keep cord far
from heat, oil and sharp edges.
•
Secure work. Use clamps or vise to hold work. It’s safer than using your hand and it frees
both hands to operate tool.
•
Keep proper footing and balance at all times.
•
Keep tool sharp and clean for better and safe performance. Follow instructions for
lubricating and changing accessories. Inspect extension cords periodically and replace
if damaged. Keep handles dry, clean and free from oil and grease.
•
Disconnect tool when not in use, before serving and when changing accessories, such
as bits.
•
Remove adjusting keys and wrenches. Check that keys and adjusting wrenches are
removed from tool before turning it on.
•
Avoid unintentional starting. Don’t carry plugged-in tool with finger on switch. Be sure
that the switch is off when plugging in.
•
Outdoor use extension cord. When tool is used outdoors, use only extension cords for
that use and so marked.
•
Watch what you are doing and use common sense. Don’t operate tool when tired.
•
Before further use of the tool, a guard or other part that is damaged should be carefully
checked to determine that it will operate properly and perform its intended function.
Check for alignment of moving parts, binding of moving parts, breakage of parts,
mounting, any other condition that may affect its operation. A guard or other part that
that is damaged should be properly repaired or rellanced by an authorized service
center unless otherwise indicated elsewhere by dealer.
•
Warning :
Use not authorized spare parts of other machines can cause incidents.
•
Repair your tool only by Authorized Service Center.
4. 4.MACHINE DESCRIPTION
1.
Chuck
2.
Ruler
3.
Handle
4.
Drill - impact selector
5.
Rotation selector
6.
Adjusting speed device
7.
Lock button
8.
Switch
9.
Speed Selector (only TPR1050/13-2 cod. 95978)
1
2
4
3
7
5
6
8