cod. 52620 - mod. SA115/VN
INSTRUCTION MANUAL ENGLISH VERSION
1.
EQUIPMENT
1 pc. Angle grinder YAMATO (without wheel)
1 pc. Handle
1 pc. Flange wrench
1 pc. Instruction Manual
2.
TECHINICAL DATA
Model
SA115/VN
Code
52620
Rated Voltage (Frequency) :
230 V (50 Hz)
Protection :
Classe II
Rated Power :
650 W
Filetto perno :
M14
No load speed :
0-12.000/min.
Grinding Wheel Ø :
115 mm.
Net Weight :
1,7
vibration: weighted acceleration m/s2. K=1,5
10,41
sound power level dB (A) K=3 dB(A)
91,1
Noise/Vibration Information
Measured values determined according to EN 60745.
Uncertainty K=3 dB.
Wear hearing protection!
The typically weighted acceleration is on the above table.
The vibration emission level given in this information sheet has been measured in accordance with a
standardised test given in EN 60745 and may be used to compare one tool with another. The vibration
emission level will vary because of the ways in which a power tool can be used and may increase above the
level given in this information sheet.
Note:
To be accurate, an estimation of the level of exposure to vibration experienced during a given period of
work should also take into account the times when the tool is switched off and when it is running but not
actually doing the job. This may significantly reduce the exposure level over the total working period.
Intended Use
The machine is intended for roughing and brushing metal and stone materials without using water. For cutting
stone, a cutting guide is required. Don’t use for cutting with equipped protection.
When using electric tools it is imperative to take the following basic safety precautions in order to reduce the
risk of electric shock, injury and fire. Read and take note of these instructions before you use this tool.
3. GENERAL SAFETY REGULATION
•
Read this manual carefully before operation to avoid the hazards such as electric shock, burn of fire.
•
The work area must be kept clean to avoid danger.
•
Pay attention to the environment, do not expose the tool in rain or humid place. Keep work area lit up.
Don’t use the tool in presence of inflammable liquid or gas.
•
Pay attention to do not touch the grounding parts, pipes, heat elements, so that to avoid electric shock.
•
Take care of the tool. Put it in dry place when not in use, and far from children.
•
Don’t overload the tool. Operate only within the load level suggested.
•
Dress properly : Don’t wear loose clothing or jewelry because they can be caught in moving parts. Rubber
gloves and non-skid footwear are recommended when working. Wear protective hair covering to contain
long hair.
