Yamaha Z150D, Руководство пользователя

Страница: 29 / 90

Basic components
24
NOTE:
After the main switch is first turned on, all
segments of the display come on as a test.
After a few seconds, the gauge will change
to normal operation. Watch the gauge when
turning on the main switch to make sure all
segments come on.
EMU26750
Fuel flow meter
The fuel flow meter displays the amount of
fuel flow over a one hour period, at the cur-
rent rate of engine operation.
If twin engines are installed on your boat, the
fuel flow meter displays the total fuel flow of
both the port and starboard engines. It also
displays “
” (for port and starboard).
Use the “ ” (set) button to rotate the fuel
flow display in the following order:
●
Press the “ ” (set) button once to display
the fuel flow of the starboard engine. An
“ ” (for starboard) will also be displayed.
●
Press the “ ” (set) button a second time
to display the fuel flow of the port engine.
A “ ” (for port) will also be displayed.
●
Press the “ ” (set) button a third time to
return the display to the total fuel flow of
both engines. “
” (for port and starboard)
will also be displayed to indicate both the
port and starboard engines.
NOTE:
●
The fuel flow meter displays gallons/hour
or liters/hour according to operator prefer-
ence. Select the desired unit of measure-
ment by setting the selector switch on the
back of the gauge during installation.
●
The fuel consumption meter and fuel
economy meter will indicate the same unit
of measurement.
EMU26760
Fuel consumption meter
This gauge displays the total amount of fuel
consumed since the gauge was last reset.
Press the “
” (mode) button repeatedly
until the indicator on the face of the gauge
points to total “
” (total). To reset the total
fuel consumption to zero, press the “ ”
(set) and “ ” (mode) buttons at the same
time.
3. Water separator warning indicator (operates
only if the sensor has been installed)
ZMU01749
1. Selector switch