–11–
A’ Insert the projection of the band to the hole of the
frame and faster the starter cable and wireharness.
Locate the end of band to left outside.
B’ To headlight lead.
C’ Route the starter cable over the heat protector.
D’ Route the temperature lead upper the heat protec-
tor.
E’ Route the reservoir tank breather hose upper the
heat protector.
F’ The fuel tank drain hose, temperature sender lead
reservoir tank breather hose must be located over
the groove.
G’ Reservoir tank breather hose above the wire-
harness.
T Insert the projection of the band (wireharness) into
the hole of the frame.
U 1: Speed sensor.
2: AC magneto connector.
3: Sidestand switch connector.
4: Oil level switch connector.
5: Meter ground lead.
V Fasten the leads (above 1
5) and starter motor
lead with a band.
W Route the fuel tank drain hose and fuel tank breath-
er hose outside of the wireharness and air chamber
hose.
X The starter cable must not be out off the guide
groove of the cover.
Y Insert the starter cable to the guide.
Z To radiator fan motor.
CABLE ROUTING
SPEC
