Yamaha YZF-R25, Руководство по обслуживанию

Страница: 77 / 456

CABLE ROUTING
2-44
7. Tail/brake light lead
8. Lean angle sensor lead
9. Rectifier/regulator coupler
10. Tail/brake light, License plate light coupler
11. Tail/brake light, License plate light connector
12. Stator coil lead
13. Negative battery lead
14. Wire harness
15. Frame
16. Starter relay
17. Rear fender
18. Mudguard
19. Rear turn signal light lead (left turn signal
light)
20. License plate light lead
21. Rear turn signal light lead (right turn signal
light)
22. ECU (engine control unit)
23. Battery
24. Negative battery sub-wire harness
25. Positive battery lead
A. Fasten the starter motor lead, negative
battery sub-wire harness, stator coil lead, and
gear position switch lead to the wire harness
with a plastic locking tie.
B. Insert the end of the coolant reservoir
breather hose into the frame pipe. Make sure
that the end of the hose protector on the
coolant reservoir breather hose contacts the
edge of the hole in the frame.
C. Install the starting circuit cut-off relay onto the
tab on the rear fender.
D. Install the starter motor lead and positive
battery lead terminals so that the crimped
section of the terminal that secures the lead is
facing upward.
E. Fasten the starter motor lead and negative
battery sub-wire harness to the wire harness
with a plastic locking tie at the location shown
in the illustration.
F. Make sure that there is no slack in the starter
motor lead and negative battery sub-wire
harness between the plastic locking ties.
G. The stator coil lead and gear position switch
lead may be routed in any order.
H. Fasten the starter motor lead, negative
battery sub-wire harness, stator coil lead, and
gear position switch lead to the wire harness
with a plastic locking tie as shown in the
illustration. Face the buckle of the plastic
locking tie outward with the end pointing
upward. Cut off the excess end of the plastic
locking tie to 3 mm (0.12 in) or less.
I. The negative battery sub-wire harness and
starter motor lead may be routed in any order.
J. The wire harness and tail/brake light lead
may be routed in any order.
K. Fasten the wire harness and tail/brake light
lead to the frame with a plastic locking tie as
shown in the illustration. Point the end of the
plastic locking tie outward. Cut off the excess
end of the plastic locking tie to 3 mm (0.12 in)
or less.
L. Install the starter relay completely onto the
tabs on the rear fender.
M. Route the rear left turn signal light lead, rear
right turn signal light lead, and license plate
light lead under the starter relay. The leads
may be routed in any order.
N. Route the rear left turn signal light lead, rear
right turn signal light lead, and license plate
light lead through the guides on the
mudguard.
O. Insert the projection on the wire harness
holder into the hole in the rear fender.
P. Fasten the starter motor lead and negative
battery sub-wire harness to the wire harness
with a plastic locking tie as shown in the
illustration. Face the buckle of the plastic
locking tie outward with the end pointing
upward. Cut off the excess end of the plastic
locking tie to 3 mm (0.12 in) or less.