Yamaha YZF-R1(P) 2002, Руководство по обслуживанию, Страница: 225 / 439

4 - 64
CHAS
STEERING HEAD
b. Remove the bearing race
3
from the lower
bracket with a floor chisel
4
and hammer.
c. Install a new rubber seal and new bearing
races.
CAUTION:
_
If the bearing race is not installed properly,
the steering head pipe could be damaged.
NOTE:
_
• Always replace the bearings and bearing
races as a set.
• Whenever the steering head is disassem-
bled, replace the rubber seal.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
4. Check:
• upper bracket
• lower bracket
(along with the steering stem)
Bends/cracks/damage
→
Replace.
EAS00683
INSTALLING THE STEERING HEAD
1. Lubricate:
• upper bearing
• lower bearing
• bearing races
2. Install:
• lower ring nut
1
• rubber washer
2
• upper ring nut
3
• lock washer
4
Refer to “CHECKING AND ADJUSTING
THE STEERING HEAD” in chapter 3.
3. Install:
• upper bracket
• steering stem nut
NOTE:
_
Temporarily tighten the steering stem nut.
4. Install:
• front fork legs
Refer to “INSTALLING THE FRONT FORK
LEGS”.
NOTE:
_
Temporarily tighten the upper and lower
bracket pinch bolts.
Recommended lubricant
Lithium-soap-based grease