Yamaha YZF-R1 2002, Информация о сервисе

Страница: 33 / 47

2-37
CABLE ROUTING
SPEC
A Route the horn lead under the rib
of bracket horn positioning the
stepped part of protector outside
the rib.
B Make the horn lead face the out-
side.
C Route the handlebar switch lead
along the groove of the guide-air.
D Handlebar switch (right) lead
coupler.
E Fasten the wire harness and
coolant temperature sensor lead
with the clamp inserted to the
frame. Point the clamp tip down-
ward.
F To starter motor.
G To pick-up coil.
H To fuel pump.
I Insert the holding clamp of the
wire harness to the frame. Route
the starter motor lead and crank-
shaft position sensor lead under
the throttle body.
J Wiring section
K Connect the leads behind the
clamp. (without crankshaft posi-
tion sensor lead)
Fasten the wire harness, speed
sensor, neutral switch, rear
brake switch, pick-up coil and
starter leads with the clamp in-
serted to the frame.
L EXUP servo motor
M To rectifier regulator
3
N Fasten the wire harness, (–)
lead, AC magneto lead and recti-
fier regulator lead junction with
the clamp inserted to the box
battery.
O Fasten the wire harness, AI sys-
tem lead, AC magneto lead, oil
level gauge lead, sidestand
switch lead and injector sub lead
with the clamp inserted to the
frame.
P Pay attention to the direction of
installation.
Q Connect the leads between the
clamp and the junction.
R Route the (–) and ACmagneto
leads under the wire harness.
28