Yamaha YZ250 2022, Руководство по эксплуатации для владельца

Страница: 155 / 274

SWINGARM
4-61
EAM30071
REMOVING THE SWINGARM
1. Use a maintenance stand to raise the rear
wheel off the ground.
WARNING
EWA13120
Securely support the vehicle so that there is
no danger of it falling over.
2. Measure:
•
Swingarm side play
• Swingarm vertical movement
a. Measure the tightening torque of the pivot
shaft nut.
b. Check the swingarm side play “A” by mov-
ing the swingarm from side to side.
If the swingarm has side-to-side play,
check the bushings, the bearings and the
collars.
c. Check the swingarm vertical movement
“B” by moving the swingarm up and down.
If swingarm vertical movement is not
smooth or if there is binding, check the
bushings, the bearings and the collars.
EAM30073
CHECKING THE SWINGARM
1. Check:
• Swingarm
Bends/cracks/damage

Replace.
2. Check:
•
Pivot shaft
Roll the pivot shaft on a flat surface.
Bends

Replace.
WARNING
EWA13770
Do not attempt to straighten a bent pivot
shaft.
3. Wash with kerosene:
• Pivot shaft
•
Bushing
• Collar
•
Bearing
4. Check:
•
Oil seal
Damage

Replace.
•
Bearing
• Thrust bearing
•
Bushing
Free play exists/unsmooth revolution/rust

Replace bearing and bushing as a set.
EAM30074
INSTALLING THE SWINGARM
1. Lubricate:
•
Bearing
• Thrust bearing
•
Bushing
• Collar
•
Oil seal
• Pivot shaft
2. Install:
• Bearing “1”
•
Oil seal “2”
(to the swingarm)
•
Collar “3”
TIP
First install the outer and then the inner bearings
to a specified depth from inside.
3. Install:
• Swingarm
TIP
Install the pivot shaft from the right.
Pivot shaft nut
85 N·m (8.5 kgf·m, 63 lb·ft)
T
R
.
.
B
A
B
A
G088936
Recommended lubricant
Molybdenum disulfide grease
Installed depth “a”
0–0.5 mm (0–0.02 in)
Installed depth “b”
6.5 mm (0.26 in)
Pivot shaft nut
85 N·m (8.5 kgf·m, 63 lb·ft)
Ne w
2 2 2
1
3 3
1
a a a
b b
a
New New New
T
R
.
.