PREPARATIONS
➤
f
Initial settings
En
33
6
Remove the IntelliBeam microphone.
The “AUTO SETUP COMPLETE” screen closes.
The IntelliBeam microphone is sensitive to heat, so should
not be placed anywhere where it could be exposed to direct
sunlight or high temperatures (such as on top of AV
equipment).
❑
AUTO SETUP via the setup menu
“Beam optimize only” or “Sound optimize only” can be measured
separately in the setup menu.
1
Place the IntelliBeam microphone at your normal
listening position, and press the SETUP (
) key.
See “Installing the IntelliBeam microphone” (p. 30) for
instructions on positioning the IntelliBeam microphone.
2
Press the
S
/
T
key to select “Beam” and then press
the ENTER key.
3
Press the
S
/
T
key to select “IntelliBeam” and then
press the ENTER key.
4
Press the
S
/
T
key to select one of the items below
and then press the ENTER key.
Settings
5
Connect the IntelliBeam microphone to this unit
after “AUTO SETUP (PREPARATION & CHECK)”
screen is displayed.
For details on connecting IntelliBeam microphone, refer to
“Using AUTO SETUP (IntelliBeam)” (p. 31).
6
Follow steps 4, 5, and 6 under “Using AUTO SETUP
(IntelliBeam)” to configure settings, and then
remove the microphone.
• When the AUTO SETUP procedure is performed from the setup menu, the menu
selection screen of the setup menu appears. Press the SETUP (
) key twice to
exit the setup menu.
INTELLIBEAM MIC
INTELLIBEAM MIC
Beam+Sound optimize
Select this optimization feature if you make
settings for the first time. This menu takes
about 3 minutes.
Beam optimize only
Use to optimize the beam angle so that the
parameter best matches your listening
environment. This menu takes about 1
minute.
Sound optimize only
Use to optimize the beam delay, volume,
and quality so that the parameters best
match your listening environment. This
menu takes about 2 minutes.
You must optimize the beam angle with
“Beam optimize only” before starting
“Sound optimize only”. Select this
optimization feature in the following cases:
• If you have opened or closed the curtains
in your listening room before using this
unit
• If you have manually set the beam angle
with “Beam optimize only”.
/
/
ENTER
S
ETUP ( )
Содержание YSP-5600
Страница 112: ...2015 Yamaha Corporation YH433B0 EN2...