10
En
Once all the connections are finished, optimize this unit for your watching/listening/playing environment by using the
“Initial Setup” menu.
Make sure of the following check points.
❏
Speakers are connected appropriately.
❏
The IR flashers are correctly connected to this
unit and attached to the connected components.
❏
The connected subwoofer is turned on and the
volume level is set to about half way (or slightly
less).
❏
The crossover frequency control of the
connected subwoofer is set to the maximum.
❏
The room is sufficiently quiet.
• Be advised that it is normal for loud test tones to be output
during the Auto Speaker Setup procedure.
• To achieve the best results, make sure the room is as quiet as
possible while the Auto Speaker Setup procedure is in progress.
If there is too much ambient noise, the results may not be
satisfactory.
Auto Speaker Setup (YPAO) uses unique technology to
optimally calibrate the frequency response and level
according to the speaker configuration, characteristics,
and their distance.
1
Turn on the TV, then set the video input
source selector of the TV to “HDMI 1” (etc.).
Refer to the owner’s manual of the TV for details.
2
Turn on the connected source devices and
subwoofer.
3
Press
POWER
to turn on this unit.
The “neoHD” logo mark appears, followed by the
“Initial Setup” menu.
y
If the Initial Setup menu does not appear, check the
following check points:
– Is the video input source selector of the TV set correctly?
– Is the TV connected to this unit correctly?
– Is the TV turned on?
– Is this unit connected to the AC wall outlet?
Initial Setup
Before starting the Initial Setup
Notes
Step 1: Auto Speaker Setup
Step 3: Source Device Setup
Step 2: TV Remote Control Setup
VOLUME
MIN
MAX
MIN
MAX
CROSSOVER
HIGH CUT
Controls of a subwoofer (example)
Step 1: Auto Speaker Setup
01EN_00_YMC-700_500_U.book Page 10 Wednesday, April 8, 2009 11:46 AM
