Yamaha YIT-W12, Руководство пользователя

Страница: 9 / 136

7
En
Troubleshooting
Refer to the table below when the unit does not function properly.
If the problem you are experiencing is not listed below or if the instructions
below do not help, contact the nearest authorized Yamaha dealer or service
center.
First, check the following:
1
The power cable of your Yamaha product is connected to an AC wall
outlet securely.
2 The latest firmware is installed on the transmitter or your iPod.
Problem/Cause Remedy
A wireless connection cannot be made. (The green indicator is off.)
Your iPod is not connected to the
transmitter firmly. Reconnect the iPod to the transmitter.
The battery of your iPod is low or run
out. Charge the iPod (p.5).
The supplied USB cable is not
connected to the transmitter (or PC)
firmly. Reconnect the USB cable.
The USB driver software is not
installed on your PC because the PC
(operating system) is not supported by
the transmitter. Use a PC (operating system) supported by
the transmitter (p.10).
A wireless connection cannot be made. (The green indicator flashes.)
The group IDs of the transmitter and
your Yamaha product are not same. Set both the products to the same group (p.3).
iPod recognition has failed because
your iPod is not supported by the
transmitter.
(In this case, the red indicator starts
flashing 30 seconds after an iPod
connection.) Use an iPod supported by the transmitter
(p.10). If you are using a supported iPod, but
still cannot establish a wireless connection,
reconnect the iPod to the transmitter. If the
problem happens frequently, disconnect the
iPod from the transmitter, restart the iPod,
and reconnect the iPod.